Posted July 26, 2017
I think I used every piece of technology in my office! 3 Legacy 2 implants placed with a Digital Guide. Flipper wearer for over 20 years. Patient had an existing Hiossen 4.5mm implant to restore.
Took a scan and got started on the tissue shaping and zirconia abutments. Did a diagnostic wax up in Meshmixer printed it and used a Drufomat and a .75mm sheet to make a matrix for box the temps and some gingivectomy. Never going to get his teeth as long as his edentulous space but we tried.
http://www.Digitalenamel.tv
Sent the case to jack at Level 3 and Frankie Acosta did the STL conversion. Printed on the Envisiontec Vida with their 240 MPa “temp” material!
Before and after! Strong bite so we went with Zirconia. #13 restored with a Hiossen tibiase in 4.5. We were lucky in that InCoris still only comes in 2 shades.
