Not a lot of space and we decided to cantilever a bridge off of the implant. My OMS placed the implant where the most bone was available and had to use a small diameter implant. Because there was no tibase for this, I just used a stock abutment and imaged it like a traditional tooth preparation. Closing the hole with wax will give a surface in the software, rather than having a hole.
It was milled with the PrimeMill and fired in the Speed Fire sintering furnace. ZirCAD Multi sinters for a long time in the Speed Fire. Not so speedy with ZirCAD! It was about 1:33 hours. The CS4 oven from Ivoclar Vivadent can sinter it in about 37 minutes, but we did this in two visits, so it didn’t matter.
The ceramic gingiva was with Jensen Dental’s MiYo Pink.